ACDU

Gary.A.Ward@Dartmouth.EDU
11 Nov 92 15:07:11 EST

Hello All,
This is directed to BD users which operate a Facstar Plus equiped with an
Automatic Cell Deposition Unit.

I have had many problems with the ACDU.

A recent problem is where I get an error message that indicates that "the
stage did not move to Y location". It further adds "the location in absolute
units is*" Then "press <enter> to continue*"

I have tried the following: powered down and restarted, reloaded the ACDU
software,
gone to Lyses program first and then to ACDU program.

Nothing seems to help.

Does this sound like a software problem or a mechanical one?

Any ideas or suggestions?

Thank you for your consideration!

Gary A Ward
Dept of Physiology, Dartmouth College, Hanover, NH, USA

Home Page Table of Contents Sponsors Web Sites
CD ROM Vol 2 was produced by staff at the Purdue University Cytometry Laboratories and distributed free of charge as an educational service to the cytometry community. If you have any comments please direct them to Dr. J. Paul Robinson, Professor & Director, PUCL, Purdue University, West Lafayette, IN 47907. Phone:(317) 494-0757; FAX (317) 494-0517; Web http://www.cyto.purdue.edu EMAIL robinson@flowcyt.cyto.purdue.edu