Re: powermac/cellquest

Matthias Haury (mhaury@pasteur.fr)
Thu, 25 Apr 1996 08:53:30 +0100

I've successfully run Cellquest 1.2.1 (get at least this version if not
even the 1.2.2) on various different powermacs for analysis with different
systems.

PowerMac 6200 Sys 7.5.1
PowerMac 7500 Sys 7.5.2 and 7.5.3
PowerMac 8500 Sys 7.5.2 and 7.5.3

And a couple of others more (also Power 7100 etc).. and in none of the
cases I have had any problems (except of the known compatibility problem
with some MS Office ODBC Extesions.. ). So I think, for analysis you can
buy pretty much any config that you want... FACSConvert also works on all
of them

Hope that helps..

Matthias

At 15:02 24/04/96, Marcia Woda wrote:
>Sorry to bother you with this: I need some suggestions for Power Mac
>configurations and O/S that fairly successfully run Cellquest 1.1.1, analysis
>only. I will make the large assumption that FACSconvert will also run on a
>power mac. Thankyou for any advice or warnings.


Home Page Table of Contents Sponsors Web Sites
CD ROM Vol 2 was produced by staff at the Purdue University Cytometry Laboratories and distributed free of charge as an educational service to the cytometry community. If you have any comments please direct them to Dr. J. Paul Robinson, Professor & Director, PUCL, Purdue University, West Lafayette, IN 47907. Phone:(317) 494-0757; FAX (317) 494-0517; Web http://www.cyto.purdue.edu EMAIL robinson@flowcyt.cyto.purdue.edu