autocloning on EPICS 752

• Messages sorted by: [ date ][ thread ][ subject ][ author ]
• Next message: Attila Tarnok: "ANTINUCLEAR ANTIGENS"
• Previous message: Joshua Cherry: "Sorting with EPICS 752 into 96 well"

We have routinely used the autocloner on our EPICS 753 for single
and multiple cell deposition into 96 well plates with good results.
The autocloner manual says that it takes the instrument 3.2 minutes
per plate to transit all 96 wells. The time needed for the instrument
to deposit a single cell when the sort population is at least 2% of
the total does not significantly add to the total sort time for each
plate. We usually allow around 5 minutes per plate when scheduling
cloner time. Hope that helps.

Justin Fishbaugh
University of Iowa
Flow Cytometry Facility

internet: system@flocyt.int-med.uiowa.edu

• Next message: Attila Tarnok: "ANTINUCLEAR ANTIGENS"
• Previous message: Joshua Cherry: "Sorting with EPICS 752 into 96 well"

CD ROM Vol 2 was produced by staff at the Purdue University Cytometry Laboratories and distributed free of charge as an educational service to the cytometry community. If you have any comments please direct them to Dr. J. Paul Robinson, Professor & Director, PUCL, Purdue University, West Lafayette, IN 47907. Phone:(317) 494-0757; FAX (317) 494-0517; Web http://www.cyto.purdue.edu EMAIL robinson@flowcyt.cyto.purdue.edu