deflection plate malfunction
Visia Dragowska (visia@terryfox.ubc.ca)
Thu, 14 Sep 1995 16:56:44 -0700
We are experiencing power failure in our left deflection plate on our BD
FACStar+.
It generally occurs after approximately 6 hrs of sorting. It takes between
10 minutes and 1 hour before the plates are functionning properly again,
after we lose power. Replacing the deflection plate does not fix the
problem, however, it has been difficult to pinpoint the source of the
problem, since the plate always regains power on its own eventually. It
also seems as though the left plate has a lower voltage, since the stream
center control will not pull the stream as far left as it will to the right.
The side streams do not seem to be affected.
Has anyone any suggestions?
Thanks in advance
CD ROM Vol 2 was produced by staff at the Purdue University Cytometry Laboratories
and distributed free of charge as an educational service to the cytometry community.
If you have any comments please direct them to Dr. J. Paul Robinson, Professor & Director, PUCL,
Purdue University, West Lafayette, IN 47907. Phone:(317) 494-0757; FAX (317) 494-0517; Web http://www.cyto.purdue.edu
EMAIL robinson@flowcyt.cyto.purdue.edu
