Calibration/ quality control

Immunology Section, HSL (imm@hslimm.demon.co.uk)
Thu, 20 Jul 1995 09:48:17 GMT

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: kukuruga%kasle1.dnet@rocdec.roc.wayne.edu: "Contract flow cytometry"
Previous message: Roger_Smith@bdis.com: "Re: Automating PC-LYSYS"

I am interested in canvasing opinions on the requirements for "adequate" quality control of flow cytometry in a research laboratory. For example, if the instrument is calibrated
daily with beads (for FS/SS and the PMT tubes) is this sufficient, or should beads be used with every sample if mean linear fluorescence is to be measured. Basically, I suppose I want
to know both the minimum requirement, and the best case scenario so that we can discuss these issues at our local flow cytometry users group meeting.

Thanks

-----
Dr. Andrew Curran
Immunology Section,
Health and Safety Laboraotry
UK

-- 
Immunology Section, HSL

Next message: kukuruga%kasle1.dnet@rocdec.roc.wayne.edu: "Contract flow cytometry"
Previous message: Roger_Smith@bdis.com: "Re: Automating PC-LYSYS"

CD ROM Vol 2 was produced by staff at the Purdue University Cytometry Laboratories and distributed free of charge as an educational service to the cytometry community. If you have any comments please direct them to Dr. J. Paul Robinson, Professor & Director, PUCL, Purdue University, West Lafayette, IN 47907. Phone:(317) 494-0757; FAX (317) 494-0517; Web http://www.cyto.purdue.edu EMAIL robinson@flowcyt.cyto.purdue.edu