 |
 |
 |
 |
>This arrangement has the minor nuisance that the PC->paintjet mode
>conflicts with the HP, so if both computers are on at once, you must
>disconnect the cable between the HP and the PC->Paintjet; then, if you want
It's a few years since we did HP310 <==> pc via GPIB, but I seem to
remember that we were able to leave both the HP and the pc connected AND
both set as system controllers. I know this is a NO NO for a GPIB bus, but
as long as the pc was off when the HP was turned on/rebooted it actually
worked! We tend to leave our HP's on 24 hours a day so this wasn't a big
problem.
Another approach, if you don't want to pull cables on/off all the time, is
to toggle the `system controller' feature (set in the pc GPIB card
software) on/off as required.
Leon.
###########################################################################
____
| | Dr. Leon Martin,
/ | _ Dept. of Pathology & Immunology,
| |-------> ( ) Monash University Medical School,
\ | ~ Commercial Rd., Prahran, Victoria,
|____| /| Australia, 3181.
__| |__ ___/ |
|_______|^^^^ --- e-mail: martin@cobra.path.monash.edu.au
| Phone: +61 3 276 2601
| Fax: +61 3 529 8359
--
###########################################################################
|
|
|
|